Feature request #4217

Allow up to 5 decimal places for Width/Size Scale Field

Added by magerlin - about 13 years ago. Updated almost 13 years ago.

Status:Closed
Priority:High
Assignee:-
Category:Symbology
Pull Request or Patch supplied:No Resolution:fixed
Easy fix?:No Copied to github as #:14180

Description

I am using Qgis with the new symbology in version 1.1.7 to illustrate traffic volumes on roads.

I use the traffic volume attribute as Size Scale Field on the road lines, but with volumes up to about 50000, the lines get far to wide even when I set the Width to the minimal value 0.01.

So would it be possible to remove this lower limit on the width?

I can of course define a new attribute as volume/1000 but it would be nice to avoid this

History

#1 Updated by Mayeul Kauffmann about 13 years ago

  • Priority changed from Normal to High

Another (more important) reason to solve this (from bug #3825 which has been closed as duplicate):

In new symbology, when selecting size, width, offsets etc. in "map unit", the minimum value is either 0.00 or 0.01, because only 2 decimal places are allowed.
At 45° North latitude, 0.01 degree=786 meters, which renders symbology based on map unit useless on lat-long data at most scales.
It is impossible to chose for instance "0.0001" (about 8 meters) to represent a small road or a track.
The resolution should be at least 5 decimal places to support a minimum of "0.00001" (80cm), which makes sense for "street maps" (e.g. with "Open Street-Maps" data in lat-long): sometimes you find a path in very narrow streets, with buildings less than two meters away from each other.

PS: note that OSM data are stored in long lat in decimal degrees with a resoultion of appriximately 1 cm.
Because of this bug, currently, it is impossible to create a topographical map on a global scale (i.e. with a global projection system, hence in degrees) with QGIS. Hence I'm raising the priority of this.

#2 Updated by Giovanni Manghi almost 13 years ago

  • Target version set to Version 1.7.4

#3 Updated by Giovanni Manghi almost 13 years ago

  • Crashes QGIS or corrupts data set to No
  • Affected QGIS version set to master
  • Subject changed from More flexibility on Width/Size Scale Field to Allow up to 5 decimal places for Width/Size Scale Field
  • Tracker changed from Feature request to Bug report

#4 Updated by Giovanni Manghi almost 13 years ago

From #1238

_Description

I request that the various Symbology size settings have a precision to at least 4 places to the right of the decimal point, especially the Line width.

Here is why: with only 0.01 precision for Outline width it is impossible to render lines on screen that are exactly one pixel, for example. There will be gaps or two pixel width short segments quite often, which are especially noticeable on straight lines.

I believe that this behavior could cause some annoyance to many users (it annoys me because I can't set a better value that I know would work) and probably complaints.

I know that when a map is rendered to a high resolution printer the precision of the size doesn't make much difference in the result, but it does affect low resolution devices like computer displays.

I have found that a value of approximately 0.26458 for Outline width results in almost no gapping on a typical Windows computer. This may vary depending on platform._

#5 Updated by Jürgen Fischer almost 13 years ago

  • Tracker changed from Bug report to Feature request

#6 Updated by Jürgen Fischer almost 13 years ago

  • Resolution set to fixed
  • Status changed from Open to Resolved

implemented in b0e6a68

#7 Updated by Giovanni Manghi almost 13 years ago

  • Status changed from Resolved to Closed

Also available in: Atom PDF